Jump to content

FLIR system - any info on how long units stay hot for / how long they have to move for to heat up ?


Recommended Posts

Posted (edited)

Can  anyone from ED eg @BIGNEWY tell us how long ground vechs have to move for the fully heat up ? do they have to be at a certain speed etc ?

how long they stay hot for when they are stationary again ?

it would be great to have this information

Many thanks in advance for replying

Edited by HC_Official
  • Like 2

No more pre-orders

Click here for tutorials for using Virpil Hardware and Software

 

Click here for Virpil Flight equipment dimensions and pictures.

.

Posted (edited)

well, a short test showed this: 10 min time have passed from mission start. miz attached. Active pause, time accelerate was used. Default FLIR contrast, gain and level
from left to right:

1. drove about 2 min, arrived and turned engine off.

2. Alert state red, engine is constantly on and in idle. he didn't move at all

3. alert state green. engine is off, cold

4. stationary, but shooting at a point for 10 min.

5. "Static" unit

unknown.png

MG2.miz

Edited by _SteelFalcon_
  • Like 2
  • 4 weeks later...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...