Deadman

OK had a few tonight and just throwing this out there but is there any reason I should not close the knob shop?

just email GVL224@ukr.net

Added a couple of knobs to the F-16 section. https://www.shapeways.com/shops/a-10c-warthog-supplies

Thanks still waiting on some parts.

beautiful work as always !!!

So is this a WIP or do you have something working ?

if you don't have a soft ware how is the arduino programed to deal with the FFB communication with the computer?

Here are a couple of sweet refueling videos I just found

Then don't make don't make a contradictory statement. There are no reviews of the throttle so no way to judge its quality or lack of. I have not seen a more expensive commercial available to the public military type throttle So to spend that kind of money ( Yes I have all so done it on real parts) but to say now I am going to get a stick but only if it is reasonable. well it sounds.. Now as far as asking me not to post on an open form or to judge my comments because you can't discuss your decisions well that is laughable.

you just dropped a grand on a throttle I don't think you have a reasonable price constraint. just sayin

I guess not

I have not seen Red in a long time his profile shows he was on in July. I don't think you will get an answer any time soon from him. Leo has a selection of switches on his site but you can use about any thing the amount of current that runs to activate the board is not that much.

that turn out nice looking very sharp

excellent work!!! looks like it is turning out quite well.

Thanks it is getting there

Here is a bit of an up date had a friend with a laser make some plywood proto types from ny drawings most came out pretty good. I have a few more pieces to test fit. And am re working the glare shield out of aluminum. Now off to a new company 2 hours away by car to be cut out of aluminum.

real f-16 MFD bezels are 4.15 square if these were something smaller they would be perfect for IP 1310/ALR RWR indicator screens.

Looks very good

Pit Porn Nice!!!

I have No idead

Found him on Facebook another commercial builder

Well I grabbed a copy looks to be a lot of net pic and fairly thin on copy.

Nope

SO The is it possible to use the PWM signal from the MSFF2 to control a amplifier/ motor driver board. then using the Hall sensors, potentiometers, or exact encoders to monitor the motors position?