Deadman

VP is a complete waist of time

sweet find your Huey is going to rock!!!!

Good luck you might want to get to know the site a bit there is a for Sal section and well750.00 is probaky more that they guys will pay for old bezels I got rid of the sets I had on eBay. I

Hum Don't think those can be re soldered this sounds like a very expensive experiment perhaps you would have better luck selling these on VP:lol:

No interest in these either scraped out for Dzus connectors and back plates

Here you go these can be made with hand tools and are accurate for the A-10C https://forums.eagle.ru/showthread.php?t=159308

Delete

Delet

Prices reduced and pots pull

There does not seam to be any interest in these so I will scrap therm for the switches.

Scrapped

Delete

I have several types of Remove before Flight Flags for sale With out any pins $5.00 each plus shipping With pins $7.00 each plus shipping With stainless screw attachment $7.00 each plus shipping Pm me for shipping cost to your location bulk discount for all 23 of the flags

Looks great congratulations on a job well done.

That is great !!!! Very cool to see some one else building with real panels

A-10 East Heritage Flight Team face book page has some great video footage of a heritage flight and this A-10 360 https://www.facebook.com/hashtag/heritageflight2017?source=feed_text&story_id=385796401784819

Hum nice to see you respect Hans for his effort. I wonder if that all so applies to the guy that drew the plans

Well may be when you are 80 but it does not help to work 60 hour weeks either :smartass: Burns you have made it very clear that your not a fan. not sure why you would waist any precious time you have left reading any of my posts.

Why Do they look well done? Spelling errors lay out errors 980.00 euros for a CDU that has the wrong fence and font lay out and there are problem hooking it up to get to work reported. Cost to quality ratting not really a selling point on these but i will say their back lighting is really good

WOW this year went by quick

ACES II seat cushion

Supper busy at the moment and it is -20 F (-28.8 C) at the moment out side So quite chilly where the panels and pit are so it may be a wile before I can check.

Here is some great footage just found it may have been posted but hey I can't get enough!!!

Last I checked Lars back plate were all at max top to bottom height leaving no gap or wiggle room for panels to fit together. Lars did a great job on his work but if you check his over all panel width it is at the max his side to side hole placement for Dzus connectors is off in the spacing form the side of the panel and from each other. This being the case there is more than likely going to be some thing off in the back lite panels that may cause a conflict. IE switches not fitting or possibly running it to supports from the side consoles. There are all so quite a few spelling / labeling errors I am sure you have all ready found those. The inconsistency of the back litght areas around knobs may all so cause you some problems . As far as the gap at the back you could cover it or make a piddle pack storage container for that area if your looking at making a replica cockpit.

Correct measurements both sets of plans are just best guesses.