Jump to content

Recommended Posts

Posted

Pressing sensor control switch aft has no effect in ACM boresight. The only way to activate vertical scan now is to switch to ACM WACQ first.

ACM vs.trk

Hardware: VPForce Rhino, FSSB R3 Ultra, Virpil WarBRD, Hotas Warthog, Winwing F15EX, Slaw Rudder, GVL224 Trio Throttle, Thrustmaster MFDs, Saitek Trim wheel, Trackir 5, Quest Pro

Posted

That's what I said. Scs left activates WACQ.

Hardware: VPForce Rhino, FSSB R3 Ultra, Virpil WarBRD, Hotas Warthog, Winwing F15EX, Slaw Rudder, GVL224 Trio Throttle, Thrustmaster MFDs, Saitek Trim wheel, Trackir 5, Quest Pro

Posted
5 minutes ago, Tholozor said:

If the HMD is on, VACQ is accessed with SCS Forward -> Left -> Aft.

Huh, yes?

I had no idea, I always lost time switching HMD off and then entering  Vert. Great advice, thanks a lot.

Saludos

Saca111

Posted (edited)
47 minutes ago, some1 said:

That's what I said. Scs left activates WACQ.

You have to go through WACQ to get to VACQ if the HMD is turned on, this is correct. If the HMD is off then VACQ is accessed just with SCS Aft in ACM mode.

SCS Aft in ACM with the HMD turned on activates UPLOOK mode for the AIM-9X.

Edited by Tholozor
  • Like 1

REAPER 51 | Tholozor
VFA-136 (c.2007): https://www.digitalcombatsimulator.com/en/files/3305981/
Arleigh Burke Destroyer Pack (2020): https://www.digitalcombatsimulator.com/en/files/3313752/

Posted
10 minutes ago, Tholozor said:

If the HMD is off then VACQ is accessed just with SCS Aft in ACM mode.

In 2.9 that does does not work. This is what this thread is about.

Hardware: VPForce Rhino, FSSB R3 Ultra, Virpil WarBRD, Hotas Warthog, Winwing F15EX, Slaw Rudder, GVL224 Trio Throttle, Thrustmaster MFDs, Saitek Trim wheel, Trackir 5, Quest Pro

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...