Jump to content

Recommended Posts

Posted
31 minutes ago, BJ55 said:

Your flap position must be Full, not Auto or Half.

Screen_240125_163243.jpg

 

Thanks, do you think that if the flaps are on half instead of full the CPL autopilot does not come into operation?

cpu:I7-6700k Z170 16GB Ram DDR4 Gtx 1080 8Gb DDR5 11GBs SSD 500 Gb 2 HDD 1Tb Evga supernova G2 850w Case Bequiet series 800 Silent base Win 10 pro 64 bit

 

My wishlist: F-35/B-17G/F4U Corsair/Yak-3/P-40B Tomahawk

Posted

Flaps Full are a landing checklist item. Use the replay function to load your track file, wait until you're at 1200ft 250kts, press Esc - Take control, disengage AP (paddle), set flaps to Full and then press CPL.

  • Like 1

I7-12700F, 64GB DDR4 XMP1 3000MHz, Asus Z670M, MSI RTX 3070 2560x1440 60Hz, TIR 5, TM WH VPC base, TM rudder, Win10 Pro

Posted

Thank a lot I'll try again and let you know bye

cpu:I7-6700k Z170 16GB Ram DDR4 Gtx 1080 8Gb DDR5 11GBs SSD 500 Gb 2 HDD 1Tb Evga supernova G2 850w Case Bequiet series 800 Silent base Win 10 pro 64 bit

 

My wishlist: F-35/B-17G/F4U Corsair/Yak-3/P-40B Tomahawk

  • ED Team
Posted
2 hours ago, ivo said:

Thanks, do you think that if the flaps are on half instead of full the CPL autopilot does not come into operation?

Yes, I mentioned that flaps must be deflected more than 37 degrees, which can be achieved only in FULL

  • Like 1
  • ED Team
Posted
4 hours ago, ivo said:

hi, I posted the flight of the mission before activating the autopilot and CPL, I deactivated everything using the A key and then another test, also deactivated T but I still have the error as shown on the left MFD post also the mission

ACLS.trk 2.44 MB · 4 downloads Ivo F-18 acls.miz 10.17 kB · 2 downloads

I have feedback from this track:

  • Commenced far too early, and should commence at 20 nm, instead started way too early at 28 nm.
  • Failed to fly commanded ROD from 6000 feet.
  • Did not make correct Platform call before switch approach when passing through 5000 feet.
  • Lowered gear way too early. Should only lower flaps at 8 nm.
  • Half flaps way too early, when descending to 1200 feet. Should only lower flays at 8 nm.
  • Did not set full flaps at 6 nm.
  • Did not fly aircraft to on-speed at 6 nm.

I hope this helps. If you have any questions, let me know. Thanks!

  • Like 1

64Sig.png
Forum RulesMy YouTube • My Discord - NineLine#0440• **How to Report a Bug**

1146563203_makefg(6).png.82dab0a01be3a361522f3fff75916ba4.png  80141746_makefg(1).png.6fa028f2fe35222644e87c786da1fabb.png  28661714_makefg(2).png.b3816386a8f83b0cceab6cb43ae2477e.png  389390805_makefg(3).png.bca83a238dd2aaf235ea3ce2873b55bc.png  216757889_makefg(4).png.35cb826069cdae5c1a164a94deaff377.png  1359338181_makefg(5).png.e6135dea01fa097e5d841ee5fb3c2dc5.png

Posted
On 1/22/2024 at 5:47 PM, NineLine said:

Tholozor beat us to the response, but we are seeing the same things. Thanks. 

Landing the F/A-18C, particularly in Case III, is certainly a complex task. We highly recommend carefully reviewing Case III landing videos, tutorials, and manual and follow the steps carefully. A good place to start:

or if you have the Supercarrier:

 

In the second video, Wags received a CUT pass grade after landing, is this intended behaviour for ACLS or from the LSO?

 1A100.png?format=1500w  

Virtual CVW-8 - The mission of Virtual Carrier Air Wing EIGHT is to provide its members with an organization committed to presenting an authentic representation of U.S. Navy Carrier Air Wing operations in training and combat environments based on the real world experience of its real fighter pilots, air intercept controllers, airbosses, and many others.

 

Posted
On 1/22/2024 at 4:41 AM, MARLAN_ said:

Have you tested in multiplayer with multiple aircraft spaced 1 (or 2) minute(s) apart? Is this working now? Last time I checked (a long time ago since I gave up on DCS CASE 3) only the first aircraft to call in would be able to use ACLS, would love to get back into CASE 3 if its working for multiplayer!

It sometimes works and sometimes does not (some people will get the entire ACLS comms sequence and others might not). I still can't count on the ATC for holding altitudes. It sometimes assigns two pilots the same holding altitude for a reason that is unclear to me.

 

  • Like 1
Posted

Ok I can now make it work but it always loses the signal near the landing point.

Thank to all

  • Like 1

cpu:I7-6700k Z170 16GB Ram DDR4 Gtx 1080 8Gb DDR5 11GBs SSD 500 Gb 2 HDD 1Tb Evga supernova G2 850w Case Bequiet series 800 Silent base Win 10 pro 64 bit

 

My wishlist: F-35/B-17G/F4U Corsair/Yak-3/P-40B Tomahawk

Posted (edited)
4 hours ago, NineLine said:

As you should, you should disengage ACLS shortly before landing as the aircraft is no longer in the beam of the ACLS.

Are you sure about this, or are you referring to a DCS limitation not present in the real world? This is my understanding of ACLS Mode 1 ops.

Mode 1 Approach -

  • At 0.5 mile controller advises the pilot to call the ball. Report - SIDE NUMBER, HORNET, COUPLED, BALL or CLARA, FUEL STATE.
  • At approximately 12.5 seconds before touchdown, the uplinked 10 SEC is displayed on the DDI and HUD.
  • After touchdown, ACL and automatic throttles are disengaged.
Edited by norman99
  • Like 1
Posted

Thanks to all of you for your help, I can now land in ACLS mode almost easily.  And thanks also to Matt Wags for the work he does, giving us moments of fun and satisfaction.

  • Like 2

cpu:I7-6700k Z170 16GB Ram DDR4 Gtx 1080 8Gb DDR5 11GBs SSD 500 Gb 2 HDD 1Tb Evga supernova G2 850w Case Bequiet series 800 Silent base Win 10 pro 64 bit

 

My wishlist: F-35/B-17G/F4U Corsair/Yak-3/P-40B Tomahawk

  • 2 weeks later...
  • ED Team
Posted
1 hour ago, skins45 said:

@Wags @BIGNEWY, it might be helpful to have a training mission specifically for ACLS super carrier landings. Maybe not include the full marshal hold, but from just before commencing down the shoot.

Will mention it to the team. 

thank you 

  • Like 2

smallCATPILOT.PNG.04bbece1b27ff1b2c193b174ec410fc0.PNG

Forum rules - DCS Crashing? Try this first - Cleanup and Repair - Discord BIGNEWY#8703 - Youtube - Patch Status

Windows 11, NVIDIA MSI RTX 3090, Intel® i9-10900K 3.70GHz, 5.30GHz Turbo, Corsair Hydro Series H150i Pro, 64GB DDR @3200, ASUS ROG Strix Z490-F Gaming, PIMAX Crystal

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...