MustangSally

Good luck with that. Might be better to just invest in a decent Windows PC?

No, curves are set in DCS

It's a screen shot from the MFD tab in Simappro

I would wait, as I think WW will be producing an IFEI

like this....https://au.element14.com/e-switch/100dp6t1b1m1qeh/toggle-switch-dpdt-5a-120vac-panel/dp/2696659

You didn't mention the cost? One cost's half a mortgage while the other is quite reasonably priced!

Win10 or 11?

See my signature...yes

You should not have to do that. My current Cubsim displays stay where I put them - Win11

Disconnect all monitors except main and do a full DCS repair/clean, reconnect WW displays and setup in Windows, start Simmapro and configure. Once that is done, run up DCS

Just checked the legislation.....no longer in force

https://www.predatormounts.com

Where in the world did you get 35% from?

I'm disagreeing with you. Warthogs are over 15yrs old now and do not come close to the WW Orion....chalk and cheese! Oh and I've also owned a couple of Warthogs over my lifetime. They're ok as entry level but just don't stack up to the adaptability, quality and feel of the Orion2.

Sorry but the Orion2 is head an shoulders better then the TM Warthog.....just no comparison!

Can't please everyone

This link isn't dead.... null

You aren't on Pre-Order. Just check your account every day and you'll see that it has been shipped with a tracking number

No to HDMI!

No, 2 x USB-C to A and 1 x USB-A to A. Top Gun MIP will require 10!

So you complained here then created a separate thread??

You can only use Winwing devices to control WinWing devices as Simappro is required. I use the Pnl rotary on my Take Off panel to control the lights over it, Combat Panel and Taurus

I doubt you'll see a replacement for at least 10yrs

Use the cockpit view of the throttle lever if you like....set the lever at the stop (in the cockpit) and use that

English and wrong forum