Jump to content

Recommended Posts

Posted

I did my best to search if this has been posted before, but I could not find anything.  Problem is fairly self explanatory, once CPG engages the target and if that target is not neutralized CPG will not re-engage unless you de-was the gun.  

Currently I am not running any mods on my installation.  Below is a short track.  Of course, there is always a possibility that I am missing something here.

64D Gun.trk

Posted

Yes this became an issue I think in the April patch. For now what I do is set the bot on gun and engage at will then I WAS and DEWAS the gun as the pilot and this seems to 'reset' the bot and it will do another burst. I repeat as necessary. 

Posted
vor einer Stunde schrieb VGlusica:

I did my best to search if this has been posted before, but I could not find anything.  Problem is fairly self explanatory, once CPG engages the target and if that target is not neutralized CPG will not re-engage unless you de-was the gun.  

Currently I am not running any mods on my installation.  Below is a short track.  Of course, there is always a possibility that I am missing something here.

64D Gun.trk 294.58 kB · 0 Downloads

Just tell george to set the gun to 10rounds per burst. So he will reengage till the bug is fixed.

Posted (edited)

It seems George is in tourist mode. When commanding him to search, the little square dashed box just roams around the screen. When you are near enemy ground forces, the dialog pops up (red Kord for example) but trying to select it doesnt work. Fails in LOBL and LOAL. In CPG position, TEDAC is unusable, just roams around the screen. The only way to stop it is to slave but then of course you cannot mannualy move it. The minute you release the slave, it starts wandering all over.george.trk

Edited by BIGNEWY
1.2

4930K @ 4.5, 32g ram, TitanPascal

Posted

I have not been able to get any reliability with the Lima Hellfires when I act as CP/G with a friend flying the same Apache.  The Lima's either impact off target by about 200 feet or hit a different target than the one designated.  We have ensured the INU is below .0012 accuracy, both LOBAL and LOAL, and IAT on/off without success.  I have tried the Lima's in SP and they never miss, so I appear to be doing the launch procedures correctly.  At one point I even had eight in the air at once in SP and all hit.  Attached is at track file.

Airfield Assault-20230519-170110.trk

  • Like 1

9800X3D (5.21GHz Turbo), MSI RTX 4090 OC 24GB, ASUS ROG Strix X870E-E GAMING Motherboard, G. Skill Trident Z5 DDR5 RAM 96GB (2x48GB), Crucial P3 Plus 4TB PCIe Gen4 3D NAND NVMe M.2 SSD, Virpil Alpha Joystick with FFBeast FFB base, T-50CM3 Throttle, MFG Xwind rudder pedals, Pimax Crystal VR.

Posted

I wonder if this is the same issue with the AI bot being unreliable with the limas, some sort of desync occurring that isn't present when operating the CPG seat solo. 

Posted
vor 1 Stunde schrieb Tshark:

I have not been able to get any reliability with the Lima Hellfires when I act as CP/G with a friend flying the same Apache.  The Lima's either impact off target by about 200 feet or hit a different target than the one designated.  We have ensured the INU is below .0012 accuracy, both LOBAL and LOAL, and IAT on/off without success.  I have tried the Lima's in SP and they never miss, so I appear to be doing the launch procedures correctly.  At one point I even had eight in the air at once in SP and all hit.  Attached is at track file.

Airfield Assault-20230519-170110.trk 34.95 MB · 0 Downloads

so you have the INU reset from time to time?

Posted

We are using cold starts and have waited extra time to make sure the INU is at .0012 accuracy before lifting (this worked in SP).  We have also tried resetting the INU.  No difference in either case when flying MP.

 

9800X3D (5.21GHz Turbo), MSI RTX 4090 OC 24GB, ASUS ROG Strix X870E-E GAMING Motherboard, G. Skill Trident Z5 DDR5 RAM 96GB (2x48GB), Crucial P3 Plus 4TB PCIe Gen4 3D NAND NVMe M.2 SSD, Virpil Alpha Joystick with FFBeast FFB base, T-50CM3 Throttle, MFG Xwind rudder pedals, Pimax Crystal VR.

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...