FCS BIT Test

[yycvor]

I'm sure the answer is something simple and obvious but....

 

How?

 

I get that both the button and switch need to be pressed at the same time, however I cant figure out how to actually click two switches at the same time. If I click and hold the first then click the next switch the first is released.

 

Any ideas?

[Raven (Elysian Angel)]

Keep the [Y]-key pressed, and then click the FCS bit button on the DDI :)

[azm]

Looks like a pilot test ))

[yycvor]

Keep the [Y]-key pressed, and then click the FCS bit button on the DDI :)

 

:pilotfly: Thanks!!!

[Kelevra9987]

On that topic:

Will the FCS WarmUp thingie be modeled later?

Because if you hold FCS BIT Switch ( Y-Button ) and press the FCS Reset, just the standard BIT Test gets started.

[QuiGon]

On that topic:

Will the FCS WarmUp thingie be modeled later?

Because if you hold FCS BIT Switch ( Y-Button ) and press the FCS Reset, just the standard BIT Test gets started.

It's already implemented, but it's the Z-button on german keyboards ;)

[Doum76]

Keep the [Y]-key pressed, and then click the FCS bit button on the DDI :)

 

 

Yeah... i should have read this thread before running the Startup Training tutorial, i was swearing so much cuz it wans'T continuing, then realised clicking and holding with mosue wasn'T working and needed key touch pressed :P

[Kelevra9987]

It's already implemented, but it's the Z-button on german keyboards ;)

 

I know, I know... but the FCS goes through the same sequence as with the normal BIT Test.

[Rainmaker]

I know, I know... but the FCS goes through the same sequence as with the normal BIT Test.

 

Perhaps normal?

[Jack McCoy]

On that topic:

Will the FCS WarmUp thingie be modeled later?

Because if you hold FCS BIT Switch ( Y-Button ) and press the FCS Reset, just the standard BIT Test gets started.

 

Press and hold FCS BIT Switch and simultaneously press and hold FCS Reset for two seconds. The controls are going to move symmetrically (10 reps) and then it will go through the regular FCS-BIT routine.

[Kelevra9987]

Oh okay, just tested it and it works. Thanks guys. :)

[Nealius]

Press and hold FCS Reset? The checklists and demos I've seen press the FCS OSB button in the BIT page. For some reason I usually have to press it twice.

[uunilenkki]

Press and hold FCS BIT Switch and simultaneously press and hold FCS Reset for two seconds. The controls are going to move symmetrically (10 reps) and then it will go through the regular FCS-BIT routine.

 

That's the excersiser, fcs reset+bit

[javelina1]

great thread, answered my question! thanks all.

[Andysim212]

Its the aircraft equivalent of the "I am not a Robot" test :)

[mariner3302]

The FCS bit page, lower right corner of the BIT page, has an FCS Option and when cycled it changes the FCS setting on its left. Does the system shown on the left of the action switch BIT check individual systems or does it change the FCS button action performed when the FCS switch/button is pressed?

[fitness88]

I'm sure the answer is something simple and obvious but....

 

How?

 

I get that both the button and switch need to be pressed at the same time, however I cant figure out how to actually click two switches at the same time. If I click and hold the first then click the next switch the first is released.

 

Any ideas?

 

 

 

I set up a macro...works perfectly.

X-52 Pro