pacotito

Lol. I'm the opposite. Cant fly center because it's not comfortable at all for me.

From the manual

Im thinking its more with DCS than the 14. Tried in the Hornet and same thing

Noticed in the training mission. If you fly inverted with full front stick the bombs will fall through the aircraft. Tested on instant mission and same thing. bombs.trk

No FBW so you can really get a good g load. Ive found around 30 you will lose a wing or two lol.

In case anyone needs it...

I haven't looked at the benchmarks yet but from what I've read this is more of a placeholder until navi comes out. I've seen reports that AMDs cost is upwards of 650+ for the card and they're making little if any profit. In very short supply also. Newegg sold out very quickly. Apparently only 100-200 cards went to the UK and some countries only got around 20.

I'd agree with this. Supposedly they are caught up to Intel on ipc. Although we wont know for sure till there's benchmarks

In general a psu is most efficient around 50% and the more you load them the "dirtier" the power gets.

Monitor cpu and gpu usage. If your gpu isnt close to 100% usage youre bottleneck is the cpu. I think DCS still only uses 2 cpu cores I could be wrong. SO depending how many cores you have cpu usage will vary since its all cores. Youd have to look at the individual cores and see if they are maxed.

I'm using the pedals for the rudders. They are a single axis.

You should be able to. I'm using an xbox 360 wireless racing wheel for rudders. Just try to assign an axis in the settings. I would think the pedals would have to be a single axis and not two separate.

Same here but it will still let you purchase. Just bought Persian Gulf map. I'm guessing the free weekend is confusing the store into thinking you already have a license for it.

I'm not sure it will work without the front right channel since that's where the volume control is on the 506

Are you talking about the microstick? I was able to map on the hornet for the tdc. You have to map it as an axis. You will want to play with it in the ch software and figure out where you need to set the dead zone. The microstick isnt all that good at recentering.

The problem you would run into would be with the front right speaker on the 506. The volume control is in the speaker and it uses a serial connection not an rca connection. So the old speaker wont work for the front right. The amp wattage is a tiny bit higher on the 506 but I dont think enough to matter.

I have the razer version. Looks exactly the same. I played around with the software and found I can configure them as joystick buttons so I can map in DCS

Did you have to program the keys in the belkin software or does it show up as a controller in DCS?

I'm currently using the xbox racing wheel gas and brake pedals for my rudder pedals. No brakes but it works pretty good

I've got that too. Haven't noticed exactly when the aoa display on the HUD goes away. When the fpi gets close to or into the bracket the aoa display disappears from the hud.

Noticed when in a 60 deg dive at 800 knots turning on balt autopilot it pulled 33gs trying to hold altitude. I would assume it has protection built in to prevent this.

Yes. The trigger on the stick works but not the spacebar

Anyone having issues with the keyboard command for trigger? Its mapped to spacebar but it wasnt working for me.

The lights and fans turn on. After that i can press the power button and it starts and has no issues

I havent been able to find a solution... i have an old 6 core 1090t amd build that is having an issue. The system wont power on with the button. The power light comes on but nothing system wise. However if I jump the green and black wire on the 24 pin and wait 10 seconds the system turns on and no issues stability wise. Runs like a champ once i jump start it. You guys have any ideas?