Jump to content

Recommended Posts

Posted

I'm getting a instant CTD under the following conditions :

  • Multiplayer
  • Cold Start
  • Adding FCR in Weapons loadout (Along with Rockets and Hellfires)
  • activating VID / Tads Feed from Pilot Seat

Hot start - No issue

No FCR - No Issue

Reproduced 3 consecutive times, and reported each time.

  • ED Team
Posted

Hey @Nightmare22

I followed your instructions to the letter and couldn't reproduce the error.

Please make sure you're not using any mods as they can cause conflicts and even crashes if not updated.

You can also try to delete the Metashaders and FXO folders on your Saved Games/DCS Folder to allow it to recompile.

If the problem persists, please share your crash log so we can have a look a it. 

dcsvader.png
Esquadra 701 - DCS Portugal - Discord

Posted
18 minutes ago, Lord Vader said:

I followed your instructions to the letter and couldn't reproduce the error.

Same here. No issues - at least in SP.

[Modules] A-10C, A-10C II, AH-64D, F-4E, F-14A/B, F-16C, F/A-18C, FC3, Ka-50, P-51D, UH-1H, CA, SC
[Maps] PG, NTTR, Normandy, Sinai, Syria, TC

[OS] Windows 11 Pro
[PC] MSI Pro Z790-A, i9-13900K, 128 GB DDR5, RTX 4090 24 GB GDDR6X, 2 x SSD 990 PRO 2 TB (M.2), Corsair 5000D Airflow, HX1500i, H150i RGB Elite, Acer X28, TM HOTAS Warthog (Grip@WarBRD Base), MS SW FFB2, Thrustmaster TFRP, TrackIR 5 & TrackClip Pro
[Checklists] A-10C, F-16C, F/A-18C, AH-64D, Ka-50, UH-1H

Posted (edited)

Can confirm TADS issue over multiplayer, cold start, without FCR attached, VR, however it happened 3 hours into the session so the track file is most likely not useful for debugging. Immediately upon selecting TADS after assigning a target to George, application hang.

Fortunately a crash/dump file was created in my case.

dcs.log-20240309-154829.zip

Edited by Nealius
Posted
Am 26.2.2024 um 09:36 schrieb Nightmare22:

I'm getting a instant CTD under the following conditions :

  • Multiplayer
  • Cold Start
  • Adding FCR in Weapons loadout (Along with Rockets and Hellfires)
  • activating VID / Tads Feed from Pilot Seat

Hot start - No issue

No FCR - No Issue

Reproduced 3 consecutive times, and reported each time.

I have 100% exactly the same issue.

Posted (edited)

Same, multiplayer, cold start, aircraft already armed, take off start flying, TSD on right MFD, go select TADS video, instant crash.

Not happening everytime, just a pain when it does.

GrayFlag Syria server.

Edited by jonsky7
  • ED Team
Posted

Guys, can you remember - what did you doing before take AH-64? Which A/C? FLIR?

Men may keep a sort of level of good, but no man has ever been able to keep on one level of evil. That road goes down and down.  
Можно держаться на одном уровне добра, но никому и никогда не удавалось удержаться на одном уровне зла. Эта дорога ведёт вниз и вниз.

G.K. Chesterton

DCS World 2.5: Часто задаваемые вопросы

Posted (edited)

Before taking an AH-64, i was using fixed wings. For example F-16, F-18 or AV-8B. Sometimes with FLIR, sometimes without FLIR.

Edited by MrEdgar84
Posted (edited)
On 3/20/2024 at 3:35 PM, USSR_Rik said:

Guys, can you remember - what did you doing before take AH-64? Which A/C? FLIR?

F-16 with LITENING for me.

Edited by Nealius
Posted (edited)

For me it’s the opposites. 
cold start works much better. Getting 45-60 FPS. Until I turn the TADS on and then 5 FPS. Frustrated to say the least on the inconsistency from day to day. As long as I don’t turn on the TADS. 

Edited by Wood

Cheers Wood

 

Windows 10, Intel i7-6700 CPU @3.40GHz, 32GB ram , GTX 4060Ti

 

Posted

Finding this same issue with crashing on selection of TADS on the left MFD.

MP server, fly F16, switch to Apache, hot start, no FCR, rearm with L type hellfires 

  • 2 weeks later...
Posted (edited)

I get the TADS crash as well and its not just isolated to cold starts but Hot starts too.

One time during a cold start on the The COOP 80s server, DCS crashed during a cold start. I activated the TADS before the camera was ready to display an image on the right screen. As soon as the camera was ready to show an image on the display the game crashed. I don't remember if the FCR was loaded. 

The game just crashed again.

1.The COOP 80s server

2.FCR loaded

3.Hot start

4.Game crash activating the TADS from Pilot seat.

I have also had a game crash from he CP/G seat when I activated the TADS on the center display.

Edited by Heliflyr
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...