Jump to content

CTD when adding FCR & Using TADS Video Feed


Recommended Posts

I'm getting a instant CTD under the following conditions :

  • Multiplayer
  • Cold Start
  • Adding FCR in Weapons loadout (Along with Rockets and Hellfires)
  • activating VID / Tads Feed from Pilot Seat

Hot start - No issue

No FCR - No Issue

Reproduced 3 consecutive times, and reported each time.

Link to comment
Share on other sites

  • ED Team

Hey @Nightmare22

I followed your instructions to the letter and couldn't reproduce the error.

Please make sure you're not using any mods as they can cause conflicts and even crashes if not updated.

You can also try to delete the Metashaders and FXO folders on your Saved Games/DCS Folder to allow it to recompile.

If the problem persists, please share your crash log so we can have a look a it. 

dcsvader.png
Esquadra 701 - DCS Portugal - Discord

Link to comment
Share on other sites

18 minutes ago, Lord Vader said:

I followed your instructions to the letter and couldn't reproduce the error.

Same here. No issues - at least in SP.

[Modules] A-10C, A-10C II, AH-64D, F-14A/B, F-16C, F/A-18C, FC3, Ka-50, P-51D, UH-1H, CA, SC
[Maps] PG, NTTR, Normandy, Sinai, Syria, TC

[OS] Windows 11 Pro
[PC] MSI Pro Z790-A, i9-13900K, 64 GB DDR5-5200, RTX 4090 24 GB GDDR6X, 2 x SSD 990 PRO 2 TB (M.2), Corsair 5000D Airflow, HX1500i, H150i RGB Elite, Acer X28, TM HOTAS Warthog (Grip@WarBRD Base), MS SW FFB2, Thrustmaster TFRP, TrackIR 5 & TrackClip Pro
[Checklists] A-10C, F-16C, F/A-18C, AH-64D, Ka-50, UH-1H

Link to comment
Share on other sites

Can confirm TADS issue over multiplayer, cold start, without FCR attached, VR, however it happened 3 hours into the session so the track file is most likely not useful for debugging. Immediately upon selecting TADS after assigning a target to George, application hang.

Fortunately a crash/dump file was created in my case.

dcs.log-20240309-154829.zip


Edited by Nealius
Link to comment
Share on other sites

Am 26.2.2024 um 09:36 schrieb Nightmare22:

I'm getting a instant CTD under the following conditions :

  • Multiplayer
  • Cold Start
  • Adding FCR in Weapons loadout (Along with Rockets and Hellfires)
  • activating VID / Tads Feed from Pilot Seat

Hot start - No issue

No FCR - No Issue

Reproduced 3 consecutive times, and reported each time.

I have 100% exactly the same issue.

Link to comment
Share on other sites

Same, multiplayer, cold start, aircraft already armed, take off start flying, TSD on right MFD, go select TADS video, instant crash.

Not happening everytime, just a pain when it does.

GrayFlag Syria server.


Edited by jonsky7
Link to comment
Share on other sites

  • ED Team

Guys, can you remember - what did you doing before take AH-64? Which A/C? FLIR?

Men may keep a sort of level of good, but no man has ever been able to keep on one level of evil. That road goes down and down.  
Можно держаться на одном уровне добра, но никому и никогда не удавалось удержаться на одном уровне зла. Эта дорога ведёт вниз и вниз.

G.K. Chesterton

DCS World 2.5: Часто задаваемые вопросы

Link to comment
Share on other sites

This is an infinite loop that can never be fixed.

In multiplayer, my ah64 FPS is below 15.


This is a native dcs engine and cannot be fixed

creator of ED's official F-16C liveries (WP,OS, 132nd, 152nd, 174th)
AH-64D livery contest winner 😅
kim_123456#3214

My user files https://shorturl.at/cdKV5
 

Link to comment
Share on other sites

For me it’s the opposites. 
cold start works much better. Getting 45-60 FPS. Until I turn the TADS on and then 5 FPS. Frustrated to say the least on the inconsistency from day to day. As long as I don’t turn on the TADS. 


Edited by Wood

[sIGPIC][/sIGPIC]

Link to comment
Share on other sites

  • 2 weeks later...

I get the TADS crash as well and its not just isolated to cold starts but Hot starts too.

One time during a cold start on the The COOP 80s server, DCS crashed during a cold start. I activated the TADS before the camera was ready to display an image on the right screen. As soon as the camera was ready to show an image on the display the game crashed. I don't remember if the FCR was loaded. 

The game just crashed again.

1.The COOP 80s server

2.FCR loaded

3.Hot start

4.Game crash activating the TADS from Pilot seat.

I have also had a game crash from he CP/G seat when I activated the TADS on the center display.


Edited by Heliflyr
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...