All Activity

Yes that binding’s been there since the module launched, and is what I have been using. In your case, if you use the other bindings and don’t bind the Centre position, of course it won’t return to centre. It works the exact same way in other modules too. You have options depending on your specific setup: if you have a switch with 3 bindable positions, use the (recall-centre-acknowledge) binding, but in most cases people will have switches with 2 bindable positions that springloads back to centre, in which case use the (Recall <> Middle) and (Acknowledge <> Middle) bindings. Most if not all modules use the exact same logic.

ну, если по-простому, то траекторией полета Вихря ты управляешь лучом, как "Малюткой" с БМП, которая наводится по проводам (за "Малюткой", или за НОТ-3, тянется провод управления. Или как сейчас, за дроном тянется оптоволоконный кабель. Или как у ПТРК с ручным наведением. А Ха25, либо Хелфаер - взлетают вверх, и ГСН начинает искать отраженный сигнал лазера на цели (лазерное пятно). Кароч - ГСН находит, грубо говоря "солнечный зайчик" на цели и ракета барабанит на него. ... типа того

I'd certainly fancy a Westland Lynx (surely there's a place in DCS for the world's "fastest" helo)(also, DCS could do with some more non-US western modules) But I'd definitely also buy the CH-53 if it were available. With the Hook and Herc, DCS is focussing more and more on cargo hauling in their sim, so the Stallion would be a great addition in that respect

https://youtu.be/3Q3C-riVXkU?si=EpHKoGxH7jG0kEAq

Забыл спросить кстати, а чем отличаются лазерно-лучевое командное и полуактивное наведение на отраженный сигнал?

there definitely are problems in your results. can you try another just IPv4? ping -4 cdn.digitalcombatsimulator.com (-4 forces ping to only IPv4) here are my results. there should be no timeouts. Pinging 1231349722.rsc.cdn77.org [109.61.91.195] with 32 bytes of data: Reply from 109.61.91.195: bytes=32 time=10ms TTL=57 Reply from 109.61.91.195: bytes=32 time=10ms TTL=57 Reply from 109.61.91.195: bytes=32 time=10ms TTL=57 Reply from 109.61.91.195: bytes=32 time=10ms TTL=57 Ping statistics for 109.61.91.195: Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milli-seconds: Minimum = 10ms, Maximum = 10ms, Average = 10ms

Hi, I don't know if you can see it in the screenshot below, but the TDC slew is disabled for the Winwing Orion Throttle. Why is that?

I have a ffbeast but also use the beast hardware trim, since i can change how it feels when i push the trim button. In DCS i loose too much force and it's harder for me to control the stick and the trim.

Hello, I have noticed a (quite minor) issue since the very beginning of the Early Access. The sound of the gun is note synchronized with the gun shots. In fact, the sound is to slow and doesn't have the same rate of fire as the gun : if you shoot a burst, you can hear around 75% of the real shots. If for example you shoot a 20 rounds burst, you can hear only 15 or 16 gun shots. As the M230 as a quite low rate of fire, this discrepancy is really noticable. Especially for short bursts. Did anybody else noticed that and is this issue known by the développers ? Have a nice day.

Took a while to get back.. track files attached. I tried with HOTAS binds and keybinds - same result. I ran a slow repair and deleted the metashader2 and fxo folders beforehand. chinookviews1.trk chinookviews2.trk

I'm guessing that's an issue with the software, or at least the compatibility of the software that you are using to run the iPad as a monitor. The easiest solution would be to buy another actual monitor. That's entirely up to you though. Sorry i can't be of any further help.

What more important thing a pilot during BVR interception would have than watching TID?

If you want to perform true CC where you go straight to the cat after traping you can disable the deck directors in SC special options or just use CVN-74.

My favourite F16 skin work ever. Wonderful weathering effects. Respect @Ala12Rv-watermanpc !

I haven't touched the KW code since leaving PC so I'm a little rusty, but from memory of implementing this it's correct behaviour. I believe the reason you aren't seeing the WP names in the screenshots from the manual is because I turned off the display of the WP names for LINE and AREA graphics when I took those screenshots, specifically because the screen becomes quite cluttered. This can be done in the RMS->SETUP page IIRC. I think this setting affects all pages that display BF graphics, i.e. it's a 'global' setting, not specific to the RMS or HSD pages. Again, I believe that is correct behaviour for the CDS we modelled. As Vakarian mentioned, all BF GRAPHICS are in fact created from WPs and CPs (can't remember if TPs?) and so when importing the drawings from the mission editor, the points of the drawing are constructed as new WPs and added to your WP list. I believe this is discussed in the manual, including the priorities of constructing the WPs from the various possible ME sources.

Heres video of my latest problem - after i returned from summer vacation to DCS, i lunched DCS and puf - problem returned. My main dcs screen escapes to wrong monitor...I have setup like this in pic And heres video link to google drive of my problem https://drive.google.com/file/d/1tzy7a9rMNgW62aN00--geWY-QTzvZJrh/view?usp=drive_link

Hi, Can you say anything about how the PSVR2 compares to the HP G2? How is the wearing comfort, the colours, the resolution, the depth perception, the performance (I use the G2 with 60 Hz)? Thank you!

+20, вес пустой, Это не правильно, в Афгане Ми-8Т, Ми-6, Ми-8ТМ поднимались и летали с грузом на 5000+

I start to think ED will make a Mangusta Helo.....

Stupendo! Complimenti

In Pimax' Crystal Super settings guide for DCS they recommend using the sharpening of NVidia GPU upscaling. https://pimax.com/de/pages/pimax-crystal-super-the-ultimate-dcs-setup-guide?_s=_s-l-f Does the sharpness slider in Pimax Play replace, override or mirror the sharpness slider of the GPU upscaling settings in Nvidia Control Panel?

I’ve been flying it quite a bit. I have been trying to adjust the roll and yaw setting and it still drifts. Admittedly it is a lot more stable than it was and the startup is a bit more realistic. I’m not a pilot but it just seems like a piston engine reaction now.

If you're on the SteamVR Beta (2.13) please opt out for now. There's an issue with it that will be solved shortly.

UP

Thanks gulredel.